Jump to content

"Contact light" does is flash when lunar module land or when the about to land


Recommended Posts

The landing contact light came on when the landing probe sensor touched the ground. This was a 5-foot (1.5 meter) wire that dangled below the landing pads. The idea was to cut the engine 5 feet above the ground, so that the plume would not blow up dust and damage the LM.

lm-landing-gear-sm.jpg

In the original design, there were 4 landing probes. However, there was concern that the probe would be bent upwards after landing, and could damage or puncture the astronaut's suits, so the probe was omitted on the leg that had the egress ladder and only 3 were installed.

Edited by Nibb31
Link to comment
Share on other sites

Ultimately it's because of horrible visibility on a tail-lander that's throwing up dust. Otherwise you have no idea where your legs are at.

Von Braun kitted his fictional ships with "touch-down shoes" in Collier's Man Will Conquer Space Soon! back in 1952.

Link to comment
Share on other sites

This thread is quite old. Please consider starting a new thread rather than reviving this one.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...