Recommended Posts

phantom000    20

Not a challenge, just something i really REALLY want to try! The idea is to complete all Mun research, that is every experiment in every biome and recover all the data before returning to Kerbin.

Has anyone ever tried that?

Share this post


Link to post
Share on other sites
Foxster    2425

A few of us have. There's been challenges in the past along these lines. 

It tends to be easier now that you can refuel your craft as you hop around the biomes. Still a nice challenge to do it without refuelling. 

 

Share this post


Link to post
Share on other sites
MinimalMinmus    256

It doesn't seem very hard, you just need to rove accross the surface reaping science, then you move to a polar LMO and do the relevant science, and you end with HMO.

Share this post


Link to post
Share on other sites
5thHorseman    7633

I landed in every (Or every one minus one, I don't recall exactly. I had already landed in a bimoe earlier in that career so could have skipped that biome) years ago. I had an orbiter with tons of fuel and a lander that could get down and back up. I orbited polar and just grabbed every biome one by one. It was quite lucrative.

I don't recall if I had *every* experiment but I'd not be surprised if I did.

Share this post


Link to post
Share on other sites
phantom000    20

My question is should i transmit the data back to kerbin? or should i store it and bring it all back at once?

Share this post


Link to post
Share on other sites
TopHeavy11    546
3 minutes ago, phantom000 said:

My question is should i transmit the data back to kerbin? or should i store it and bring it all back at once?

With this type of haul, it's no longer a question of "Should I bring it home?" but rather a question of "Do I have enough EC to transmit it back home?" Honestly, if you exhausted the entire Mun in one trip, then the bounty will be well more then you would want to risk on re-entry and parachutes. I way transmit it all (or at least most of it.)

Share this post


Link to post
Share on other sites
eloquentJane    1904
8 minutes ago, phantom000 said:

My question is should i transmit the data back to kerbin? or should i store it and bring it all back at once?

I'd say, transmit the data that has 100% transmission rate (crew reports, EVA reports, etc), and keep everything else so that you get all the science points.

Share this post


Link to post
Share on other sites
Randazzo    1427
55 minutes ago, eloquentJane said:

I'd say, transmit the data that has 100% transmission rate (crew reports, EVA reports, etc), and keep everything else so that you get all the science points.

Agreed. It seems a waste of time to bother going to every biome only to transmit the data and get a fraction of the science.

Share this post


Link to post
Share on other sites
eloquentJane    1904
3 minutes ago, Randazzo said:

Agreed. It seems a waste of time to bother going to every biome only to transmit the data and get a fraction of the science.

Also, aside from not transmitting, if you want to get the maximum possible science then you should take a science container as well as a command pod. You can then store one copy of experiments like the materials study in the science container, and the other copy in the command pod. This ensures that you get the most data out of the experiments, and don't have to go back to redo them for the rest of the science points.

Share this post


Link to post
Share on other sites
phantom000    20

I am trying to design a lander of some kind that can carry all the experiments down to the surface then back into orbit, dock with a station to transfer the data and refuel then head back down. Its not easy, it needs a docking port, an RCS system, landing struts and at least one of every experiment. If anyone has done this before, could you show me a picture?

 

Share this post


Link to post
Share on other sites
eloquentJane    1904

I suggest you design your lander to be able to reach a polar orbit, and put your mothership in a polar orbit when you're doing the mission. This is because you can only land on the equator from an equatorial orbit without having to do an expensive plane change, but you can land anywhere from a polar orbit. It does mean you'll sometimes have to wait a while for your desired landing site to be beneath your orbit, but at least there's minimal plane changing required.

Share this post


Link to post
Share on other sites
Tex_NL    2030

All biomes in one trip is pretty easy when you bring a rover and a lot of patience.

Share this post


Link to post
Share on other sites
TopHeavy11    546
On 2/11/2017 at 11:06 AM, Tex_NL said:

All biomes in one trip is pretty easy when you bring a rover and a lot of patience.

You have to consider low and high above science too

Share this post


Link to post
Share on other sites
Tex_NL    2030
2 minutes ago, TopHeavy11 said:

You have to consider low and high above science too

Low is easy. Just hit a bump at speed, jump and hit all science at one with an action key.
High is also very easy from a polar orbit.

Share this post


Link to post
Share on other sites
phantom000    20

I am going to try the Rover approach. Landings are quite tricky and if you get one wrong you would have to start over. I think driving a cross the surface would be much safer.

ztyBKFS.jpg

The only question is how do i get it there? I have to:

1. Get it into Kerbin's orbit

2. Get it to Mun

3. Get it down to Mun's surface safely

4. Remove it from the landing vehicle.

FYI, i am doing this in Research Mode, so if you were wondering 'why i do not use *insert part here*' it is probably because i do not have it yet.

 

Share this post


Link to post
Share on other sites
overkill13    58

Looks top heavy with a skinny wheelbase.  That's a recipe for disaster.  Get it all closer to ground level and put on an additional reaction wheel and turn on SAS when you start moving.  Also know that roving the whole of Mun is gonna take forever.

Share this post


Link to post
Share on other sites
LoSBoL    327
On ‎11‎-‎2‎-‎2017 at 3:56 PM, phantom000 said:

I am trying to design a lander of some kind that can carry all the experiments down to the surface then back into orbit, dock with a station to transfer the data and refuel then head back down. Its not easy, it needs a docking port, an RCS system, landing struts and at least one of every experiment. If anyone has done this before, could you show me a picture?

 

I used this to hop around, works pretty good, has all the science experiments on board + 4 science canisters and a DV of around 2500 to do a few Mun hops before refueling in polar orbit.

1k0.jpg

1k0.jpg

Can't bring the lander home to Kerbin though, It docks to my LKO station which has multiple descent pods. Rescued Kerbals are mandated to grab some science before they bring themselves down to Kerbin.

1k0.jpg

 

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now