aerodynamic overlay issue

[CRV-WKD]

in sph my aerodynamic overlay isn't showing properly, i get the blue ball showing where the lift occurs but no arrow to show direction and ball is only applied when wings are already attached not when i'm trying to figure out where to attache them,,, hope you understand what i mean and v grateful if someone could help thanks, please ask if there's anything i didn't explain properly   

picture

[Jas0n]

It's because you have FAR installed. It has always done this for as long as I can remember. I presume because FAR calculates aerodynamics based on voxels and would require an impractical amount of calculations for updating it before the part was placed down.

[CRV-WKD]

ahhh  thankyou 

dont know much about what goes on behind the scenes but as soon as you put part down the overlay adjust instantly, if it can adjust that fast you'd think that it could adjust that fast before part is placed. 

 

 

 

[Jas0n]

7 hours ago, CRV-WKD said:

ahhh  thankyou 

dont know much about what goes on behind the scenes but as soon as you put part down the overlay adjust instantly, if it can adjust that fast you'd think that it could adjust that fast before part is placed. 

 

 

 

For that you'll have to go ask Ferram