Heat Patch for Convert-O-Tron 125

[RepairByImpact]

This is a little mod that allows the Convert-O-Tron 125 to reach 100% efficiency without using excessive heat control methods.

I have been frustrated many times by my inability to heat control the COT 125 and I read about many others who have been as well. 

I did some searching and found that the overheating of the COT 125 might be a feature of the part.  Since a small object has a higher surface area to volume

ratio, it should be easier to control high core temperatures than a similar object of larger size. 

It is my first patch and this is my first post so please go gently. 

I have only posted this to CurseForge here

The image below is slightly different than the one on the Curse page.  This one represents the patch better by showing only one active radiator holding it at 100% at 1000 K

If you take the radiator off or inactivate it, the heat will climb rapidly.

Requires Module Manager.  I tested it on MM 2.8.1 and 3.0.1.

 

CC-BY License - See file or Creative Commons for details

Edited December 28, 2017 by RepairByImpact
grammer and clarity