MiffedStarfish 1,378 Posted February 22, 2018 When you are plotting manuever nodes, the readout on the side of the navball shows how much D/V the burn shall take, and how much you have done. This works fine when you have one node active, but if you have multiple, it only shows the closest, which can be annoying when you’re planning a transit to Jool, but you can’t see how much D/V you’ll need to capture because you have a correction burn of 2m/s active as well. I suggest a way to cycle through which manuever node is active on the navball. 4 Share this post Link to post Share on other sites
Martian Emigrant 1,080 Posted February 23, 2018 I approve this suggestion. ME 1 Share this post Link to post Share on other sites
The Dunatian 685 Posted February 23, 2018 Sounds good. 1 Share this post Link to post Share on other sites
5thHorseman 10,239 Posted February 23, 2018 (edited) I like it. I have used PreciseNode for just this purpose while making nodes with the stock tool. Edited February 23, 2018 by 5thHorseman 1 Share this post Link to post Share on other sites
Human Person 641 Posted February 23, 2018 Hmm, why not have a little additional readout that simply sums up all maneuver nodes that have been plotted out? 3 Share this post Link to post Share on other sites
Martian Emigrant 1,080 Posted February 23, 2018 15 hours ago, Human Person said: Hmm, why not have a little additional readout that simply sums up all maneuver nodes that have been plotted out? You mean like layers? Successive rings around the nav ball? Works for me. ME 2 Share this post Link to post Share on other sites
