Fine adjustment in PAW

[Rich T]

Is there a keyboard combination or keyboard mouse combination that will allow direct entry or fine adjustment of the PAW slider values in the VAB/SPH? I can't seem to get my servos set back to 0.0. I know you can do it in the controller but I will be using the Axis group.

[Geschosskopf]

10 minutes ago, Rich T said:

Is there a keyboard combination or keyboard mouse combination that will allow direct entry or fine adjustment of the PAW slider values in the VAB/SPH? I can't seem to get my servos set back to 0.0. I know you can do it in the controller but I will be using the Axis group.

All I've found for this situation is to close the PAW, rotate the camera slightly, and reopen the PAW.  Or sometimes do that and/or lift my mouse off the pad and move it an inch or 2 in a random directions.  I know of no keyboard controls that decrease mouse inputs nor of any way to type in values directly.

[Rich T]

1 hour ago, Geschosskopf said:

All I've found for this situation is to close the PAW, rotate the camera slightly, and reopen the PAW.  Or sometimes do that and/or lift my mouse off the pad and move it an inch or 2 in a random directions.  I know of no keyboard controls that decrease mouse inputs nor of any way to type in values directly.

Thank you for the advise

[FleshJeb]

3 hours ago, Geschosskopf said:

All I've found for this situation is to close the PAW, rotate the camera slightly, and reopen the PAW.  Or sometimes do that and/or lift my mouse off the pad and move it an inch or 2 in a random directions.  I know of no keyboard controls that decrease mouse inputs nor of any way to type in values directly.

I wish that worked more than 5% of the time at 1280x1024. I have to exit the SPH and come back in. Most of the time I just rip the part out and replace it. Fortunately, I build everything with snap on, so replicating positions and alignments isn't that hard.

Do you know if there's a UI scaling setting that enlarges the PAW?

[Geschosskopf]

6 hours ago, FleshJeb said:

I wish that worked more than 5% of the time at 1280x1024. I have to exit the SPH and come back in. Most of the time I just rip the part out and replace it. Fortunately, I build everything with snap on, so replicating positions and alignments isn't that hard.

Do you know if there's a UI scaling setting that enlarges the PAW?

I have the same problem, and also generally just replace parts I can't get where I want, too.  And no, I don't know how to enlarge the PAW.

[Zhetaan]

Since it's become startlingly relevant:

There's a point release for that. (1.7.3)