Jump to content

[SOLVED] Help to make a custom fairing part

kurgut
 Share

Recommended Posts

kurgut

kurgut

Posted
Posted (edited)

Hi,
I'm trying to make a custom fairing part, for my personal use, using stock fairings textures, but a custom base.
I took a dummy 1.25m part here to work with, and copied over revelant parts of the cfg from the stock 1.25m fairing, and changing its attach nodes to match it. So far so good. BUT, the actual fairing shell starts a bit above the base, leaving an undesired gap... Do you know at which part should I look ? I'm pretty sure it's defined (I hope) in the ModuleProceduralFairing section, but can't figure out which one...
screenshot0.png

Thanks a lot ! :) 
Peace

update : was indeed in this section of the part module, defined iirc by       "pivot = 0,0.17,0"

Edited by kurgut
Link to comment
Share on other sites
This thread is quite old. Please consider starting a new thread rather than reviving this one.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing
×
×
  • Create New...