krytie

Hi All, i cant seem to find any info on my issue.. i just installed remotetech2 today (i already have mechjeb, kas, crew manifest, kethane and tac fuel balancer).. and got to work setting up my starter comms network. I made a simple satellite and launch rocket for it. I launched with mechjeb ascent guidance to get out the atmosphere. I then disabled the auto pilot and used the mechjeb maneuver planner to create the maneuver node for me to enter stable orbit. i plugged the details into the flight computer, hit the node button to line up and entered stable circular orbit. after that i used the same method to perform a maneuver to enter a Molniya like orbit (i am planning to have 4 sats in similar orbits with each rotated around 90 degrees to get decent coverage). I used the same saved rocket design, and the second sat went up without a hitch. When i got to the third one. the first maneuver to enter orbit went fine, i put in the details for the second maneuver and hit the node button and the rocket settled about a qtr of the nav ball away from the blue mark, when the burn came.. I ended up with an off centre orbit (due to the rocket not lining up with the node) and it was too small. I scheduled another maneuver to correct the orbit, hit the node button. and the rocket began to spin quite quickly, head over heels, and would not stop. i only got it to stop when i hit the node button again to stop it attempting to line up. i used the node button in smart A.S.S and it lined up with the node as expected. i have attempted this launch 6 times now. i have double checked that i have comms to ksc and enough power. I have restarted my PC. the first maneuver to get into orbit always works, the second gives me the off centre blue mark, and the 3rd and every subsequent maneuvers cause the uncontrollable spinning.. i am setting up these maneuvers at 1x Has anyone seen this behavior? Am i making a mistake i am not aware of ? Are there any troubleshooting tips i should follow from here? Thanks in advance!