Found a visual bug in the v02 pre-release beta. not sure if here's where to post it or not. I see it on the extendatrons right angles (i didn't look a the straight ones) both full and half. When I placed the part using either of the two straight attachment nodes, not the 90* node, the wrong half of the part moves when actuated, however the actual nodes and anything attached to it behaves correctly. it seems to be just the visuals thats messed up. I made a short video to demonstrate it, however I can't seem to upload it. heres a picture kind of showing whats happening http://i.imgur.com/E3gJoms.png. the extendatron is attached to the root part on one of the end nodes, so the long part should stay stationary and the 90* angle should move relative to the root and stay stationary relative to the attached moving nosecone. the opposite is happening and the and the angle piece stay stationary to the root while the long piece moves. this only happens when attached at either end. the part works correctly when the angle piece is attached to the preceding part.
