Search the Community
Showing results for tags 'enginecluster'.
Found 1 result
-
When I make engine clusters for the sake of a higher TWR, I usually don't use the built-in adapters. Usually, I will take a radially-attachable nosecone and put it on 3-4x symmetry, then put the engines on the bottom. I then use the displacement tool to push them together in the center to look like and engine cluster. I do this for three reasons: 1) I think the partially visible nosecone looks better than the adapters 2) the nosecones don't make it less aerodynamic (as far as I know) and 3) I can't figure out a way to attach anything below the adapters (like if it were an upper stage and I need a decoupler below, I would have to now have several stacks of fuel tanks because of the inability to put a decoupler in the middle), and the above mentioned method leaves the node on the bottom of the fuel tank stack open. I usually place a girder or two on this node until they just stick out below my engines, then put a decoupler on the end of that. This way I can have a central stack below this for a lower stage. The issue with this is that it is unshrouded and the two sections of rocket are joined by a thin girder. Does anyone have a more effective way of doing this that still looks okay, or is this the best possible solution? Thanks for any input.
