Circumnavigate Kerbin Completed - Sector 7 Indy Xtreme GT

[Castille7]

Sector 7 Space Laboratories - Circumnavigate Kerbin Elcano Challenge

The beginning was still looking like Craft testing for me, a few times I started the Mission and tweaked the Craft until I was satisfied with the first leg of the Long Journey. Immediately I noticed it was less troublesome to travel by water rather than by land so I chose to make a water travel route. With speeds up to 70 m/s on the water and the ability to use Warp at 3x helped towards the end of the trip because my first attempt at warp 3x the craft was not holding a good course so I didn't bother with it for awhile. Most the the trip was only at 1x or 2x warp. I am sure the Mission Time could have been reduced drastically if I would have discovered this sooner. The Craft was designed with Mk2 Inline Cockpit, an ISRU Converter, Fuel Cell Arrays, Thermoelectric Generators, Small holding Tanks, Wheesley Engines, Drill-o-Matic, Z-4k Rechargeable Batteries, Large Reaction Wheel, Structural Intakes and with a great suspension system.

Craft Type: Catamaran/Amphibious - Indy Xtreme GT (Indy Xtreme Global Transport)

Mission Start Date: 11.06.2015

Engineer's Report

Parts:165

Mass 26.0t

Height:5.5m

Width:9.8m

Length:12.2m

Crew

Pilot: Jebediah Kerman

Co-Pilot: Bill Kerman

Driller/Surveyor/Engineer: Camgard Kerman

The Route

Photo Album

Javascript is disabled. View full album

The Craft that inspired the design for the Indy Xtreme Global Transport

Craft File

Indy Xtreme

Craft File

Indy Xtreme GT