stability assist wobble in space with one SAS mode / not the others.

[neko77025]

I teird to look up my issue , but did not see anything like this.

 

Ok , So i have played alot of KSP .. steam shows 900+ hours.  I know its more then that with some plays not using steam. 

 

So I am having Issues with stability assist ( stability assist only ) in space.    When I am in space and turn on SAS and click stability assist ... my craft(s) start going nuts .... I am not talking a little bit ... makes it impossible to control.   However,  If I click on any other of the SAS buttons .. it is 100% fine.    This is only A issue in space as far as I can tell.

 

I have A crap ton of mods ... 

hmm .. Now that I think about it ... it might only be on probes.    Tested A few of my sats (remote tech installed ) .. eh have 1 prob and one ASAS .. I would turn the torque on / off of ea of them and test .. if one or both of the torque(s) are on .. it starts too slowly go crazy.   If both of it just floats.    This is only with to stability assist on ... If I were to make SAS point prograde its fine ( or any of the others )

 

Any Idea ? ... I want to post video ... but I play in 5760 x 1080p and it took me forever to get it in that .. dont want too take it out of that .. and not sure where i could post A video with 5760 x 1080p.

Have A wicked crap ton of mods that are all installed 100% right and updated.  

 

Going to check if manned ships do it also

 

 

Thanks neko

[FancyMouse]

Use RT flight computer holds instead of stock SAS holds. Or you can try to eliminate signal delay and see if it works. I'm seeing similar thing for unmanned probe outside Kerbin SoI, and my theory is that RT adds the signal delay that affects stock SAS as well, and it screws stock SAS. I haven't verified my theory, though - but using RT flight computer instead does help.