Land the BFE-5000 on the moon

[Supergamervictor]

The crazies thing to do in KSP if you dare to do.Land the BFE-5000 liquid engine on the moon.You may edit the part .cfg to land. No landing legs allowed! i manage to this.

[xPDxTV]

The BFE uses 1 tank of fuel so fast, it\'s i would almost say impossible, but more likely near impossible to use just 1 tank to take off, enter escape velocity towards the moon, get into a decaying orbit around the moon and then land.

[maltesh]

It\'s not impossible.

It should be noted that the challenge is 'Land the BFE 5000 on the Mun.'

There is no requirement that the BFE-5000 be thrusting at any point during the trip. As a result, the challenge could be restated as 'Land an extremely-unweildy mass-50 payload on the Mun.'

[Supergamervictor]

It\'s not impossible.

It should be noted that the challenge is 'Land the BFE 5000 on the Mun.'

There is no requirement that the BFE-5000 be thrusting at any point during the trip. As a result, the challenge could be restated as 'Land an extremely-unweildy mass-50 payload on the Mun.'

you are allowed to change the part.cfg like i did.

[ddavis425]

you are allowed to change the part.cfg like i did.

To be honest, it\'s not really a challenge if you are allowed to change the part.cfg. I could easily make it have a huge amount of thrust with a miniscule burn rate and an unnoticable amount of weight, making it possible to launch and land on only 1 tank.

[Sean Mirrsen]

To be honest, it\'s not really a challenge if you are allowed to change the part.cfg. I could easily make it have a huge amount of thrust with a miniscule burn rate and an unnoticable amount of weight, making it possible to launch and land on only 1 tank.

You did see the screenshot he attached right? He only used a half-tank.

The real challenge is to do this without cheating any more than the BFE-5000 itself already does.

[simplemunrockets]

There is only one solution to this.

*plasters 50,000 tons of dead weight all over the engine*