Suggestion: Once a maneuver plan is created, switch the guidance to target instead of prograde

[rben13]

One of the most frequent mistakes I make is forgetting to switch to target before a maneuver node. I suspect this happens to newbies a lot as well. 

It would also be nice to have an indication, when building the rocket, of how much torque/RCS power is available to the rocket at each stage vs. the max mass and average mass.

[rben13]

The Minimus target ring is very difficult to see. Could you make the rings around targets brighter?

I would like to be able to see the AP and PE of resulting orbit of the maneuver I am planning.

Though the DV is being displayed for the upcoming stages, the mass of fuel and oxidizer is not.

[rben13]

Bug: After completing a burn to lower my periapsis around Minimus, the periapsis kept changing, despite my engines being off.

[rben13]

Bug: After taking off from Minimus, I was unable to get any orbit line. For some reason, it showed my AP as being negative. Upon escaping Minimus SOI, I still had a negative AP showing. Perhaps there is a roll over bug in the AP/PE display?