twich22 Posted March 21, 2023 Share Posted March 21, 2023 Any part that is attached to another part might change its rotation when trying to attach one assembly to a separate assembly. This is especially true if the assembly has been rotated or inverted, or if an individual part has been rotated or changed from its original orientation. For example, place a large fuel tank and then place a docking port on it. Then rotate the docking port 90 degrees. Now take the whole assembly and drag it across a separate assembly a few times. You will likely see that the docking port has reset its orientation or changed its orientation to something new. Whats more, If you had symmetry mode on, and had multiple of the same assembly, you might find that only SOME of the docking ports had changed orientation while others remained the same, even though they should be perfectly identical. Link to comment Share on other sites More sharing options...
Ashandalar Posted March 21, 2023 Share Posted March 21, 2023 I'm also experiencing this. Here's a short clip of a Clamp-O-Tron Jr docking port rotating 180° when I try to attach a lander assembly to an orbiter: https://i.imgur.com/yKRF7KD.mp4 Link to comment Share on other sites More sharing options...
Recommended Posts