Jump to content

Remote Tech Starter Launch


Recommended Posts

The goal of this rocket is too set up an orbital comm system in 1 launch to allow unmanned flight.

Mods used

  1. Remote Tech v5 http://kerbalspaceprogram.com/remotetech-3/
  2. Remote Tech Compatability v5 http://kerbalspaceprogram.com/remotetech-probe-compatability/
  3. Mech Jeb 2.0.6 *Will update file on 2.0 full release http://forum.kerbalspaceprogram.com/showthread.php/12384-PLUGIN-PART-0-19-Anatid-Robotics-MuMech-MechJeb-Autopilot-v2-0-7
  4. KW Rocketry v0.2.33 http://kerbalspaceprogram.com/0-18-1-kw-rocketry-overhauled/
  5. Zenith rocket family http://forum.kerbalspaceprogram.com/showthread.php/24787-0-19-1-Zenith-rocket-family

The payload is a 1 man pod connected to a poodle orbital engine and 6 small probes in fairings. The Launch vehicle is a modified Zenith III, it will run out of fuel on an optimum launch with a periapsis of at approximately -5km. The orbital engine can finish circularizing and still have approximately 3500 delta v for orbital changes and a possible mun transfer.

The Probes have a Comunotron 16 for communication with a range of 9Mm it is enough for orbital communications from geo-stationary orbit and is just long enough to bridge over too a high mun orbit. Abort will disconnect and launch the manned capsule and disable all engines, 10 will open the parachute, 1 will jettison fairings suggested before circularizing orbit.

http://www.filedropper.com/remotetechstarter

Link to comment
Share on other sites

This thread is quite old. Please consider starting a new thread rather than reviving this one.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...