Jump to content

MagTech Iridium-TR


Recommended Posts

Repost from the other thread. Perhaps one of the simplest (vanilla) to orbit machines I have used.

Presenting the newest MagTech Rocket, the Iridium-TR! Simple yet functional, this Iridium Class light lifter will put three Kerbal 'Astroneers'© into an orbit with sufficient fuel to bring them home, or push them to the great beyond!

This two stage model model can reach a height of nearly 50km on the primary stage, and achieves 300km at 3300km/sec at second stage burnout, on an unguided vertical launch*.

May this cheap model enable your future endeavors into the final frontier!

*Note: Flight was stabilized. Flight reached a height of 1111K within 10 minutes.

=>Usage notes: An initial set of decouplers will 'decouple' you from the launchpad. If you desire more maneuverability, jettison the previous stage at full burn, your ship will remain attached and in control (see pic). This also eliminates any massive slowdowns the game may or may not be suffering.

Link to comment
Share on other sites

I've been using a similar design with Boosters underneath all three tricoupled engines (boosters were next to useless). I was attempting to perform a orbital flight, and messed up. Still into the flight but it looks like it will end up doing a high elliptical-half orbit

2316K at T+01:06:04

I'll give you the full debrief hopefully in an hours time :'(

Link to comment
Share on other sites

This thread is quite old. Please consider starting a new thread rather than reviving this one.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...