Adjacent control flaps flapping in opposite directions from each other?

[yevoc]

Pictures probably say it all. I have been struggling with this problem for hours now and can not make it go away. No matter where I place the flaps on the wing (above, below) and no matter how I rotate the flap when placing it, I can not get that last flap to rotate in the same direction with the rest of them. The center of mass is fore of all flaps.

What am I missing? Thanks!

UPDATE: jdsutton's post below is the answer!

Edited September 12, 2013 by yevoc

[jdsutton]

It's not facing exactly straight forward, that could throw the calculations off a bit. I've found that placing flaps at an angle like that can cause some strange control issues as well.

[Moar Boosters]

Thats odd. I don't think you've done anything wrong, that looks like a bug. It thinks that bit of wing is on the other side of the plane.

Did you try deleting the wing section and rebuilding it?

[yevoc]

Did you try deleting the wing section and rebuilding it?

Yes, and unfortunately it yields the same results. I'll keep tinkering and post this as a bug I suppose? It's definitely proven resilient to my efforts.

[yevoc]

It's not facing exactly straight forward, that could throw the calculations off a bit.

jdsutton is right. When I rotated (yaw) the flaps to face more forward, the outer-most flaps started working properly again.

Thanks!