Uncontrolable roll (FAR)

[rpayne88]

So I've managed to build my first spaceplane that will reach orbit (finally.) The problem is with reentry. It will not burn up (I use DR) but it will begin to roll uncontrollably (I also use FAR,) causing the G-loading to tear it apart (and rip off the VG ejection module.) My profile was to bring its periapsis to 10km and let drag do the rest.I'll post a screen shot in the morning. Any ideas?

Edit: Here they are:

Side:

Front:

Top(ish):

sgt_flyer: its rolling about its longitudinal axis.

Edited September 24, 2013 by rpayne88

[sgt_flyer]

By roll, what do you mean ? Does it starts to tumble during reentry ? In this case, i think you have too much weight at the rear of your spaceplane and not enough drag at the rear. (Maybe try to add some flaps at the rear configured as aerobrakes - and deploy them during reentry) - basically, you should ensure that your center of drag is behind the center of mass during reentry, else the center of mass will try to get in front of the center of drag, causing the spaceship to tumble.