Jump to content

Fly under the R&D center bridge.


Recommended Posts

The bridge, it tantalizes the adventurous nature of the common Kerbal. They yearn to risk its tight clearances and sharp turn - in any sort of vehicle that doesn't depend on ground contact for support and steering.

10 points for flying under it with any sort of vehicle and not crashing into any of the R&D buildings.

+50 for a manned vehicle.

+75 for a rotary propeller vehicle.

+100 for a jet propelled vehicle.

+500 for a liquid fueled rocket propelled vehicle.

+700 for a solid rocket propelled vehicle.

+1000 for doing it without wings. (Not for slow hovers with a VTOL vehicle.) Wings may be installed for the approach then jettisoned, which could make the next score a bit difficult.

+500 for a safe landing anywhere after going under the bridge.

or

+550 for a safe landing back on the KSC runway or launchpad you started from.

No points off for taxiing from the launchpad or runway to a different takeoff position, but the takeoff must be outside the R&D center.

Highest speed under the bridge is trump for ties in points.

Note: Propulsion modifiers NOT cumulative. Use the number for the highest valued propulsion installed, which must be active during the flight under the bridge. The propulsion scored must be the primary motive power at the time of the passage, so simply sticking a couple of Seperatrons on a prop plane doesn't score 700 points. :sticktongue:

Link to comment
Share on other sites

This thread is quite old. Please consider starting a new thread rather than reviving this one.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...