Allow part clipping by default

[Runescope]

So, until they fix the problem of parts not attaching even though the mirrored part does, I'm always allowing part clipping in the SPH/VAB. Does anyone know if it's possible to enable that in one of the cfg files?

Edited September 24, 2014 by Runescope

[blizzy78]

No, that's not possible.

[Carsogen]

Not sure if this helps but if you reduce the symmetry (Shift+X) and then increase it back again (X) without moving the part it should allow the mirrored part to connect, although if you'd rather just enable part clipping cause it's easier I believe it stays on once activated.

[peachoftree]

the editor extensions mod has a shortcut (opt+z I think) that quickly toggles part clipping. It also has a lot of extra features that are really useful.

[Runescope]

Not sure if this helps but if you reduce the symmetry (Shift+X) and then increase it back again (X) without moving the part it should allow the mirrored part to connect, although if you'd rather just enable part clipping cause it's easier I believe it stays on once activated.

Yup, I've used that, it's about 20% effective, as is the 'rotate it all the way around' trick, and 'move it off and back on' trick. I shouldn't have to fiddle with the part for five minutes to get it to latch on where it's supposed to be able to latch on.

And yes, once you turn on part clipping it stays on for that game session, but I'm lazy and was hoping to avoid that. lol