I'm asking because I'm not good at English and couldn't find the information.
I've seen a phenomenon where the position of the resized part changes when you save-load an airframe with the resized part attached.
The part in question had a color variation parameter.
The color variations may have had an effect.
If I change the color after installing the problematic part and save it, it will not be out of position the next time I load it. If I try to save load again, the problem will occur.
Are you experiencing these problems outside of me?
Also, is it being debated? https://twitter.com/miyo0919/status/1260233270886723586