I've found a few issues in my latest play. Not sure if this is the right thread to post all of them but it seems my best option... please tell me if I should report any of these problems somewhere else :)
1. MechJeb can't calculate dv anymore. I used MJ quite normally for a while, then all of the sudden the dv window disappeared (I don't even see it in the MJ options anymore). I tried resetting all MJ config to defaults but still doesn't work. I was able to create a custom window that shows dv but it only works in flight mode, not in VAB/SPH. Any ideas what's wrong?
2. Since MJ doesn't work, I installed Kerbal Engineer Redux. In the editor it works fine but in flight mode it can't calculate the current's stage dv. The next stage(s) show up fine but whenever I activate a new stage it just shows "0/1234 m/s". Same for TWR, it will actually show my TWR as "0/1.42", as if the engine wasn't enabled. I just updated all my mods via ckan and the problem didn't go away. Any clues?
3. My Kerbals switch professions! Whenever I hire a pilot I can only send him for a single flight, upon recovering him he'll switch to being an engineer. Also I think my pilots are not providing SAS, but maybe that's because they switch to being engineers as soon as I launch, I haven't checked again.
4. My MK1 pod is crazy! I put just a pod in orbit, no sas. If I turn RCS on it will start spinning randomly. No trimming involved.
5. Reentry from LEO requires no ablator. If I don't use a heatshield some parts do explode, but if I use one it consumes at most 3 or 4 points of the ablator coming back from LEO. I'm using DR with default settings. Is this reasonable?
