jpwerner1505

I have been using the stock settings/inputs up until this point, but I was hoping to use the custom deadband capabilities of AFBW to improve the control a bit. That is my fallback option, was just hoping there's a way to use this mod.

@linuxgurugamer I am using the Logitech Extreme 3D Pro, which has axis #3 as a slider for the throttle. AFBW is recognizing it correctly and can be configured, but is classifying the axis as a -1 to 1 input, instead of 0 to 1. This is causing an issue with the throttle input, where half of the range of the slider is being lost (-1 to 0 makes no change to throttle input). With this range, -1 should be 0% output, 0 should be 50%, and 1 would be 100%. On the screenshot below with Axis #3 at -0.197 the slider value is just slightly negative, so should be at ~40% throttle output, but is actually at 0. Here Axis #3 is at 0.448, which is approximately 75%, but throttle is displaying in-game at 50%. Here is the axis configuration I am using: I apologize if I'm missing a setting that would fix this, but I haven't been able to find it. The joystick inputs and mod seem to be working fine otherwise, it just seems to be misinterpreting the range of the axis. I did try adjusting both the positive and negative dead zones to see if that would cut off the bottom half of the axis, but it did not change the behavior. Any insight you can provide would be greatly appreciated. I don't have logs to upload, as the mod seems to be working correctly, but if you do require them, I can pull them and upload. Thank you!