Search the Community

I am looking for somebody willing to generate me a NEW, LONGER functional hollow ring part model (as in a .Mu file and associated textures) for my Netherdyne Mass Driver Mod! Before anyone says hollow ring parts are impossible, take a look at the mod, and know that I am currently using hollow ring models, and they work. I am just looking for somebody to generate me a part model that is LONGER that I can replace the current model with. Note that the model NEEDS TO BE RE-SCALEABLE as the latest version of the mod includes re-scaled parts from 0.625 meters all the way up to 5 meters, each using an identical copy of the same base model- but with a different "rescaleFactor =" value in its part config. I am looking for somebody to generate me three models- one with 4-5 times the length of the current 2.5 meter internal diameter model (that is, it can comfortably fit a 2.5 meter part within its internal cavity- the exact internal diameter is a bit over 2.8 meters I think), one with 7-8 times the length, and a third with 11-12 times the length. All must have AT LEAST the same usable internal dimensions as the current model- that is one can fit a part of the same width (although slightly larger internal diameter than the current model is acceptable). I aim to test each model and see what the practical limits are for how long/powerful of a tube part I can use for the mass drivers, and still have the networking function work correctly (I know already at least a 2-fold increase in length will cause absolutely no issues, from the 5 meter part being 2x as long as the 2.5 meter version). If they ALL work correctly, I will use one of the two longer models and abandon the other two. Repeating, simple geometries and textures for the model are not only accepted, but suggested. Take a look at the current part model, and know that I find it unnecessarily complex. A simple, thick hollow tube with a texture made to look like Aluminum (*NOT* Copper coils, which is what the current mod erroneously shows- even though the only existing mass driver designs for StarTeam use Aluminum coils, possibly due to their high mass:strength ratio and the ability to readily obtain large amounts of Aluminum on the Moon...) covering the entire interior would be the preferred basic model design... Please ONLY respond if you are able to provide such a part. This is NOT a thread for discussing what you think of the mod, saying such part models are impossible (they're not, the mod currently uses a model with ring-shaped colliders and it works fine), etc. Please ONLY respond in regards to offering to make such a model, pointing me in the direction of somebody you know who can do so for me, etc. Regards, Northstar