Jump to content

Stock Drag Race Launcher


Azimech

Recommended Posts

 

xy1o5No.png

 

 

This drag strip is 1/2 mile long. It has finish lines at 1/8, 1/4 and 1/2 mile. The ramps and the christmas tree are controlled through action groups.

Instructions:

* Use Mechjeb for controlling your vehicles, set the rover autopilot to 90.5 degrees or they will run off the runway.

* When attaching a vehicle, don't touch the decouplers. Load a new vehicle and use the "merge" option. Attach the vehicle to the decoupler and slide it to the right spot.

* The use of Editor Extensions Redux is recommended.

* You can delete the pavilions for a reduction in part count.

* There are two ramp sizes, smaller for the beige wheels and bigger for the grey wheels. Use offset to slide the right type into place.

* NEVER USE THE UNDO FUNCTION. It will reset the struts which make the finish lines.

* Put drivers in the crew cabin.

* When loading the simulation, first put the drivers in their seats. After that, set throttle to 0. Decouple both vehicles, set both rover autopilots to 90.5 degrees. Start the engines and throttle to max. When both vehicles are at max thrust, switch to the launcher. Press 9 and then press 8. They're off!

Picture album: http://imgur.com/a/pO6UD

Download link: https://kerbalx.com/Azimech/77I--Drag-Race-Launcher-10

 

 

 

Link to comment
Share on other sites

This thread is quite old. Please consider starting a new thread rather than reviving this one.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...