Jump to content

[0.16 Stock] Rover


Recommended Posts

Here is my newly designed rover :)

It can spin out of control and still survive, had some test runs on Kerbin an it started spinning and hopping around at more than 50m/s on the ground and nothing broke ^^

If you start rolling and want the up side up again you can just retract the lading gear, roll and voila! :D

You can use RCS or the rockter at the back to move it

screenshot8fi.png

screenshot14ua.png

screenshot11rg.png

Edited by hollyghost
Link to comment
Share on other sites

My stock rover has two wheels on bottom and two on top, at 90 degree angles, even so it has occasional clearance issues with the terrain and scrape the bottom.

Do you think your rover is stable over terrain because it has good clearance on the bottom?

Link to comment
Share on other sites

My stock rover has two wheels on bottom and two on top, at 90 degree angles, even so it has occasional clearance issues with the terrain and scrape the bottom.

Do you think your rover is stable over terrain because it has good clearance on the bottom?

Didn't have any issues yet. I noticed I go "into" the ground from time to time when there is a little elevation but usually it never goes any higher then the wheels and I think it's just a bug.

And what do you mean by stable? It happens that it tips over the the side so I don't have the up-side of my craft to be paralell to the ground but even then you can still control it or just stop and turn it over again :)

And I also tried going up and down hills, and it works! ^^

Link to comment
Share on other sites

This thread is quite old. Please consider starting a new thread rather than reviving this one.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...