Jump to content

Guess who's not going back to Kerbin


AxelNova

Recommended Posts

My mission did not go as expected... I blame the kerbals.

ZVtLszX.png

*UPDATE* Rover landing mission unsuccessful too many times... I would like a helping hand with rover landings.. Suggestions anyone?

Edited by AxelNova
Link to comment
Share on other sites

Och! Bummer. Congratulations on building a capable design.

There is still hope. It might be possible to right the ship. Drain all the RCS fuel from the top tanks to the big one below. Retract and extend landing gear while rolling around. Either you'll be back on your feet, or more things will explode. If you do manage to get upright, right-click on the opposite engine and shut it down, leaving the other two activated.

Or, just press F9. You did quicksave before the descent, right?

Link to comment
Share on other sites

Well a rescue mission is on it's way because I can't get the lander to work. And if I could there would not be enough fuel to get back to Kerbin anyway. You should've seen the landing it took me like 20 minutes and it was hilarious and stresfull at the same time. I'm also sending a tiny rover to Mun as well for some in depth exploration. The rover is ready to go but I have trouble getting it to space. I don't know where's the issue because the rover is veeeeery tiny so it should not be a problem but for some reason it still is. Anyone give me a hand?

Link to comment
Share on other sites

Good luck with the rescue! You'll learn a lot when designing rescue rockets.

With a little practice, that ship should land fine, assuming you have enough fuel.

That's a lot of RCS you've got there.

Sure you need that much on a landing stage?

Link to comment
Share on other sites

Turned out to come in handy while landing. For a n00b in KSP like me there's never enough RCS but I think I learned from my mistakes and the rover will land safely and then the rescue rocket.

Link to comment
Share on other sites

This thread is quite old. Please consider starting a new thread rather than reviving this one.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...