Conics modes?

[Ekkoria]

Hello all,

I've been seeing some (older) talk about conics modes in settings.cfg, and a Google search didn't turn up anything newer than about June, so I figured I'd ask. Is there any benefit to changing CONIC_PATCH_DRAW_MODE or CONIC_PATCH_LIMIT? I read the explanations on the older threads, but I was just wondering if these are still applicable. Thanks!

Edited December 27, 2013 by Ekkoria

[Specialist290]

If this thread is one of the ones you're talking about, then yes, I believe the information is still valid as of 0.23.

Edited December 27, 2013 by Specialist290

[Ekkoria]

Thanks a lot, I think I'll stick with mode 3 then!