rose4100

This may have been address already, so I apologize in advance. Is there a way in the settings to turn off the need for connections. I love the parts in this mod, they looks so much better than stock antennas. The reason I'm asking is because i'm having trouble establishing a connection between Duna and Kerbin. I have a small Satelite network orbiting Kerbin and have an automated craft on its way to Duna. When it was getting close i lost connection and could not regain it. There is nothing blocking line of site and both ends have an active GX-128 addressed to eachother. Also they are well within the 400G range. Thanks for the help guys.

What is the formula for Supply usage per kerbal? Is it simply 1 unit of supplies per day? If this has been addressed before, i'm sorry.

It took me a couple nights but I finally made it into the K - Prize Challenge. No special Kudos, just basic completion. I nearly ran out of fuel and it took me nearly 4 hours ingame time to air break enough to get out of orbit.

I updated and still get an uncontrollable "wobble" when i switch my unmanned craft to SAS without flight computer direction.

Hey Athlonic, do you have a link to remote tech 1.6? The most recent one i can find is v1.5.2.

RemoteTech just updated to v1.5.2 and it fixed the issue. Thanks for looking into it orcmaul. But now i have another problem where my craft goes into an uncontrollable "wobble" when I turn on SAS with an unmanned vehicle. I'll ask the guys over on the RemoteTech page.

I currently have ModuleManager.2.5.1 installed. As for mods i'm using: BoxSat vA.02.b Chatter-0.8.0 DMagic_Orbital_Science_0.9.1 Karbonite_0.5.0 KAS_0.4.10 MKS_0.22.1 Near_Future_Construction-0.3.1 Near_Future_Solar-0.3.1 Near_Future_Electrical-0.3.1 Regolith_PRE_0.0.2 RemoteTech-v1.5.1 StationScience-1.4 TacLifeSupport_0.10.1.13 I've been using these for a while (since before 0.9 release). Those that were updated for 0.9 I deleted and replaced with the newer versions. Thank you for taking a look at my problem guys. I appreciate the time.

Has anyone had a "wobble" issue, where once a little ways from Kerbin (roughly Minmus), your probe will begin to wobble when its only on SAS? Once i give it a remote trajectory (like node or prograde) it stops. While not a big issue in orbit or transit to its target, its a very big problem when i'm trying to land because it throws my controlled retro burns way off.

Since 0.9 was released i'm having an issue with the Quad tape antenna and the dish. When i right click on them i get 4 separate activation buttons. Also, when i activate the antenna will deploy then close up again immediately. Has anyone else had this problem?