Twin Boar engine in cargo bays?!

[Arugela]

I should have asked this a while ago, before I designed a whole ship. But I thought it would fit from messing with it.

Does anyone know for certain if you can fit a twin boar engine into the largest cargo bays? I have a ship based on it and I was wondering if it can fit in and out. Specifically has anyone actually done it? The top fits fine by the looks of it. But the bottom where the engines are seems like it colides with the inside of the bay. I don't know if that matters though as it could not have a solid surface there. Does anyone know for certain if this is an issue?

I'll put up a pic later of the engine in the cargo bay.

Edit:

Edited November 7, 2015 by Arugela

[Foxster]

Yes, it fit.

It needs to be rotated 90° in a kinda counter-intuitive way.

[Arugela]

Finally added the pic to the first post.

Will that setup fit or will the overhang stop it? Do they all need to be condensed onto one access? I'm worried because even the side that is not sticking out of the wall is still touching the inside of the cargo bay.

Those are stacked twin boar engines btw. That is why there are four instead of two showing. Should I assume those all need to be lined up?

Edited November 7, 2015 by Arugela

[TheXRuler]

Parts on the same vessel never collide (that I am aware of) however some veeery bad things can happen if one of your clipped parts becomes detached so beware

[Vanamonde]

Removed some posts. Keep the discussions on-topic, please.