Jump to content

Stock Community Space Station (SCSS)


Recommended Posts

Putting the link up for the next guy:

https://www.dropbox.com/s/b20vs42nrmk68t6/persistent.sfs

I didn't do anything major to anything that was already there; instead, I put a rover and a small base core on Minmus. For the rover, I'd highly advise disabling the motors on the rear wheels, as otherwise it likes to do backflips. Driving is kinda hilarious on Minmus due to the low gravity, and I'd advise remapping the rover controls to the translation ones but having your fingers ready to control pod torque anyway.

That said, if you know what you're doing, you can make the rover breakdance :P

Also, a screenshot showing the rover and base together, along with pilot Tombree Kerman:

SCSS-03IthacaBaseZugZugRover_zps28396204.png

Link to comment
Share on other sites

Well sadly I was not able to get much done, actually nothing done. My gpu was having problems loading any space craft I switched to or tried to launch. So just use the persistence file Specialist put up. Good luck to the next guy.

Link to comment
Share on other sites

Yay! I liked my previous save better anyway.

http://www.2shared.com/file/ljMjK6rO/persistent.html

[i did do an update straight from the link on the front page, but my ascent profile was wrong and I used too much fuel to land the descent stage as well as the rover. The rover survived, but I didn't get a pretty landing site.]

Link to comment
Share on other sites

This thread is quite old. Please consider starting a new thread rather than reviving this one.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...