Dnarbnellih2 Posted September 12, 2018 Share Posted September 12, 2018 (edited) I'm making an interplanetary station in ksp with SSPX and other realistic mods, it's made for aerobraking, but the centrifuge keeps burning up, everything else does stay safe behind the big inflatable thing, even other parts from SSPX, but the centrifuges act like there is literally nothing between them and the atmosphere. I've even taken procedural heat shields, put the, right in front of the thing, and not only does it not help, the shield itself used no ablator. Basically I think the centrifuges are ignoring the heat shields. **Edit** Writing this question just gave me an idea, what if the visible profile of the shrank down centrifuge didn't match the actual one, like if it appeared collapsed but actually wasn't. I just tested this, and I took a procedural heat shield and made it 20m, and it actually protected the centrifuge, @Nertea, I think I may have found the solution to the problem, any ideas on how to fix this? Edited September 12, 2018 by Dnarbnellih2 Link to comment Share on other sites More sharing options...
Nertea Posted September 12, 2018 Share Posted September 12, 2018 Ah, this is the place I was directing you to post this. Link to comment Share on other sites More sharing options...
Dnarbnellih2 Posted September 13, 2018 Author Share Posted September 13, 2018 (edited) Oops, thanks again! How do I close a thread? Edited September 13, 2018 by Dnarbnellih2 Link to comment Share on other sites More sharing options...
Geonovast Posted September 13, 2018 Share Posted September 13, 2018 4 minutes ago, Dnarbnellih2 said: Oops, thanks again! How do I close a thread? Click the "Report Post" button on your original post, and request a moderator to lock the thread. Link to comment Share on other sites More sharing options...
Dnarbnellih2 Posted September 13, 2018 Author Share Posted September 13, 2018 Ok, thanks! Link to comment Share on other sites More sharing options...
Dman979 Posted September 13, 2018 Share Posted September 13, 2018 Thread locked at OP request. Link to comment Share on other sites More sharing options...
Recommended Posts