Jump to content

Kron series (Kron 6 end of mission) - temporary halt of program


lajoswinkler

Recommended Posts

Kassini probe communications interrupted by solar storm hitting Sarnus ~50 days before Kron 6 passed Sarnus orbit. Kron 6 did not detect it as it was not close enough at the time. Communications are still semi-garbled between Kassini and Kerbin as magnetic interference dissipates, but it appears to have made contact with Kron 6. Traveller 3 has entered Urlum orbit, and Traveller 4 is on final approach to Neidon. They will also confirm Kron 6 trajectory.

Link to comment
Share on other sites

On 9/6/2016 at 10:15 AM, KAL 9000 said:

Uhh... Um... Look, a butterfly! RUUUN!

Ok, actually, I was going to have the Asteroid Redirect probe rendezvous with Kron 6, but there was a Klaw failure... Seriously, that's actually what happened.

Oh, oh. Sorry about that.

...but how exactly were you expecting to accelerate a Class E up to third cosmic speed? Antimatter drive?

Link to comment
Share on other sites

Kerty report #6

gerty.png

- day: 949

- speed: 4959.2 m/s

- distance from Kerbol: 413 million km

- crossing Neidon's orbit (entering unknown distances for Kron missions)

- 15k food units produced

- four solar storms occured, hitting Kerbin, Eve and Moho

- unable to repair the converter; Bill Kerman will have to do it during EVA

Link to comment
Share on other sites

Have Bill replace the AE-35 unit. Travelers 3 and 4 confirmed course. Side Note: Contact re-established with Kaos 3, all systems functioning and a little bit of fuel left. Permission to redirect it to a Kuiper Belt Buckle Object?

Link to comment
Share on other sites

9 hours ago, greenTurtle1134 said:

So... @KAL 9000, you and @lajoswinkler share a universe/planet/plotline/cannon? Can you make this clear, so it doesn't look like you're roleplaying?

No, they don't. I'm pretty sure it's all @lajoswinkler's save. KAL 9000 gave Lajoswinkler 2 probes to take out to Plock.

And, how is the ship holding up? No RUDs?

Edited by DMSP
Link to comment
Share on other sites

59 minutes ago, greenTurtle1134 said:

So... @KAL 9000, you and @lajoswinkler share a universe/planet/plotline/cannon? Can you make this clear, so it doesn't look like you're roleplaying?

Kron 6 has four forumers' probes. Two were made by KAL 9000. It's not roleplaying at all.

34 minutes ago, DMSP said:

No, they don't. I'm pretty sure it's all @lajoswinkler's save. KAL 9000 gave Lajoswinkler 2 probes to take out to Plock.

And, how is the ship holding up? Now RUDs?

It will reach Plock very soon. Everything is basically OK.

Link to comment
Share on other sites

Kerty report #7

gerty.png

- day: 1033

- navigational values set relative to Plockian frame of reference -

- speed: 4721.3 m/s

- distance: 611,850 km

- entering Plock's SOI

- 5k food units produced

- reaching periapsis in 1 day, 12 h

- coronal mass ejection arriving in 3 days, 22 h

- no additional damage

- proceeding to end Kerbal hibernation

Link to comment
Share on other sites

The probes can help Kerty out with some of these tasks, here's their diagnostic on the crew:

Jeb-checking status... nominal

Bill-checking status... nominal

Bob-checking status... nominal 

Val-checking status... nominal 

Initiating wake up for all crew... 25%... 50%... 75%... 100%... Done! Wake up complete.

Link to comment
Share on other sites

The crew has been awakened and they're feeling fine.

Bob was the last one to wake up.

093A654EAA2F98AF1B0DDEA67775A20A1A6A7DD0

 

Pilot Valentina Kerman is being briefed by Kerty on the ship's status and news from Kerbin that have been received over the antenna during the past three years, almost.

3B5606A868656AE4E6D090FA84AAB0AE78A20136

 

Plock and Karen are barely visible in the distance as two tiny circles. Time until periapsis is 12 hours.

1E4B902EC3F79F177C6268E01F8D89B098B7EC24

 

Kron 6 is hurling towards Plock's south pole at over 4600 m/s and calculations show that decceleration will last for a bit more than half an hour.

Link to comment
Share on other sites

This thread is quite old. Please consider starting a new thread rather than reviving this one.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...