Two bugs/problems with Poodle Single Bell

[Serenity]

Hello, i found these two problems with the Poodle

https://imgur.com/UgsRWP1The engine plate is z fighting with it and also just a minor problem. there isnt really a certain engine plate Variant that is close to being short or long to fit a bit better in shroud.

Edited July 14, 2020 by Boyster

[RealKerbal3x]

@Boyster If you've got a 2.5m engine you shouldn't really need an engine plate. You can just put a 2.5m decoupler underneath and there should be no z-fighting.

[Serenity]

On 7/13/2020 at 12:05 PM, RealKerbal3x said:

@Boyster If you've got a 2.5m engine you shouldn't really need an engine plate. You can just put a 2.5m decoupler underneath and there should be no z-fighting.

I know m8 but maybe for some reason i want to put an engine plate.

If we played this game only with what it was needed all we would built is the same 100 crafts.

Anyways.

Edited July 14, 2020 by Boyster

[HansAcker]

16 hours ago, Boyster said:

I know m8 but maybe for some reason i want to put an engine plate.

You'll probably always see some z-fighting when you place an engine with exactly the tank diameter into a shroud of the same dimensions. I *guess* you could reduce the engine model scale by just a fraction by editing/patching the part config (I assume that it's possible - never tried it :).

In the case of the 2.5m engine plate, z-fighting also appears with Skiff and Mastodon (in their "Full" variants) and to a lesser extend with the Wolfhound engine.