Construction
Explore Questions
There are no popular reports to show right now
-
Construction Revert to VAB causes radial parts to disappear or causes unassembled ship to appear in VAB floor
0 votes0 replies -
Construction Using 'Undo' After Attaching Two Parts By Their Nodes Disconnects Them Instead Of Deleting One
0 votes0 replies -
Construction Procedural wing slider numbers are not precise [Values don't round up to the number shown (e.g. case where 0.10 =/= 0.10)]
10 votes0 replies -
5 votes5 replies
-
Construction Setting a radially attached docking port as the assembly anchor breaks the assembly when leaving and reentering the VAB [Craft into the ground/floor]
3 votes3 replies
23 questions in this forum
-
Construction Revert to VAB causes radial parts to disappear or causes unassembled ship to appear in VAB floor
0 votes0 replies -
Construction Using 'Undo' After Attaching Two Parts By Their Nodes Disconnects Them Instead Of Deleting One
0 votes0 replies -
Construction Mirror symmetry broken on some parts (RF-AD-SL-2500, Mammoth-II and some science parts)
4 votes6 replies -
5 votes5 replies
-
25 votes6 replies
-
Construction Procedural wing slider numbers are not precise [Values don't round up to the number shown (e.g. case where 0.10 =/= 0.10)]
10 votes0 replies -
Construction Center of mass indicator does not get updated when modifying fuel amount values in fuel tanks [or at all until toggling symmetry or picking up craft]
19 votes16 replies -
Construction Docking Ports In Symmetry Are Not Placed When Attempting To Connect To Radial Parts In Symmetry [and copying it again results in a crash]
5 votes3 replies -
12 votes4 replies
-
Construction Parts breakdancing while using the translate tool when root part set to a part on symmetry
6 votes2 replies -
Construction Setting a radially attached docking port as the assembly anchor breaks the assembly when leaving and reentering the VAB [Craft into the ground/floor]
3 votes3 replies -
7 votes1 reply
-
47 votes21 replies
-
33 votes1 reply
-
Construction Struts in Symmetry Don't Connect Correctly When 2 Inline Parts are Facing Away/Towards Each Other
28 votes16 replies -
14 votes4 replies
-
1 vote0 replies
-
32 votes7 replies
-
Construction The deltaV calculator in VAB doesn't distinguish between fuel types and calculates wrong
6 votes3 replies -
Construction Horrendously bugged craft file causing game to get stuck in VAB upon launch, with softlock upon revert [both strut connectors are connected to the same part]
1 vote2 replies -
8 votes3 replies
-
Construction DeltaV Tool not working when switching between different launch assemblies in the same workspace [only the first assembly placed in the VAB will have DV calculated]
32 votes14 replies -
Construction Unable to place Fuel Lines and Struts in Symmetry Mode after deleting one of them and press Undo
3 votes1 reply