XOC2008 Posted August 9, 2018 Share Posted August 9, 2018 6 minutes ago, Toonu said: Hello, what is AI unclamping//clamping in the AI part? It allows you to tune higher than the usual set of numbers in the AI. Link to comment Share on other sites More sharing options...
SpannerMonkey(smce) Posted August 9, 2018 Share Posted August 9, 2018 (edited) 12 hours ago, Xd the great said: Is there increased range for emp weapons in space/less dense atmos? Hi you can have a missile that works well in space or a missile that works well in atmosphere, what you can't have is a missile that works just as well in both environments. There are currently NO space capable EMP missiles(non of the team have made one yet or to my knowledge even studied the effect out of atmosphere) Burn time of all the missiles are set in seconds, the engine runs for exactly the set length of time. Speeds of space missiles are extreme (due to no drag) even when used with minimal thrust, so within the described burn time a dedicated space missile will travel considerably further for the same thrust value, than a missile operating in atmosphere. The EMP effect range as mentioned is set in the part cfg , and will not and I see no valid reason why it should, have a larger range in space , a radio pulse is a radio pulse no matter the environment ( I've checked the science and wave propagation in atmosphere and space are similar enough to not worry about special settings for either environment, imo of course) Edited August 9, 2018 by SpannerMonkey(smce) Link to comment Share on other sites More sharing options...
SpannerMonkey(smce) Posted August 9, 2018 Share Posted August 9, 2018 1 hour ago, Toonu said: Hello, what is AI unclamping//clamping in the AI part? Hi following on from XOC2008's comment, Although un clamping is now possible for the PAI as it has been for the surface AI for some time, the PAI testing that was done seems to indicate that increasing the settings may not produce the results expected, wild settings require a wild aircraft to use them, and even then the benefits are dubious. Conversely un clamping the surface AI, clicking the goes to 11 option , allows an infinite amount of adjustment and allows the AI to control any surface craft of any size, from less than a few hundred kilos with wheels to the largest ship I have which at full size afloat, weight in excess of 100000kg's The requirements for a small wheeled vehicle, a tracked vehicle and a large warship are very different, and i urge everyone to experiment to find what really works for the craft. Link to comment Share on other sites More sharing options...
Xd the great Posted August 9, 2018 Share Posted August 9, 2018 Ah thanks @SpannerMonkey(smce). Link to comment Share on other sites More sharing options...
Xd the great Posted August 9, 2018 Share Posted August 9, 2018 How can I get the new drone? Link to comment Share on other sites More sharing options...
SpannerMonkey(smce) Posted August 9, 2018 Share Posted August 9, 2018 1 minute ago, Xd the great said: How can I get the new drone? Open the BDA folder, Open the crafts file , copy or cut the new drone craft file. Open your save folder, Open ships folder, Open SPH folder and paste the craft file there . Load the game Link to comment Share on other sites More sharing options...
Xd the great Posted August 9, 2018 Share Posted August 9, 2018 Ahh thanks. Just a side note, most modders put demo craft as a stock craft, so that people can just copy the ship file along with the gamedata and post it in the directory. Link to comment Share on other sites More sharing options...
DoctorDavinci Posted August 9, 2018 Author Share Posted August 9, 2018 (edited) 9 minutes ago, Xd the great said: Ahh thanks. Just a side note, most modders put demo craft as a stock craft, so that people can just copy the ship file along with the gamedata and post it in the directory. Listen to you most knowledgeable of users ... Don't care what most modders do and the fact remains this is BDAc, not stock Not interested in your side notes nor your misinformation Edited August 9, 2018 by DoctorDavinci Link to comment Share on other sites More sharing options...
Toonu Posted August 9, 2018 Share Posted August 9, 2018 One more thing, my plane when attacking ground target with guns always shots bellow target (due to gravity probably). But if I put the guns up, the plane miss other planes and overshoots them. Any ideas? Link to comment Share on other sites More sharing options...
SpannerMonkey(smce) Posted August 9, 2018 Share Posted August 9, 2018 (edited) 39 minutes ago, Toonu said: One more thing, my plane when attacking ground target with guns always shots bellow target (due to gravity probably). But if I put the guns up, the plane miss other planes and overshoots them. Any ideas? On 8/8/2018 at 3:42 AM, Papa_Joe said: NOTE: There has been a long standing issue with guns accuracy and the AI. Seem when the AI fIres, it can't hit the broad side of a barn (OK, it can if the barn jumps in front of it, but not intentionally.) As was reported and well characterized by @greydragon70 (Thanks) and many others (thanks as well!). we are taking a deep look at this issue. Based on our rather extensive testing, this problem was introduced some time around version 1.0 or 1.1. We are working on narrowing it down, but that is going back quite a ways. I just wanted everyone to know we are taking a hard look at this as we realize it is an unacceptable condition. Hi just to reiterate , currently AI when used with aircraft has about as much chance of scoring a direct hit as Halley's comet does of landing in my bathroom sink. It is a lamentable situation that has been stealthily getting worse for a while. The coding team have already spent hours (days) digging and tweaking, trying to get to the bottom of the problem and the testers many hours (weeks) repeating the same tests over and over. There is some suspicion that changes in KSP however small, have had a greater detrimental effect overall than previously encountered. TLDR; it's broken, we are working on rectification PS emphasis on PJ's quote added for clarity Edited August 9, 2018 by SpannerMonkey(smce) Link to comment Share on other sites More sharing options...
Xd the great Posted August 10, 2018 Share Posted August 10, 2018 (edited) 13 hours ago, DoctorDavinci said: Listen to you most knowledgeable of users ... Don't care what most modders do and the fact remains this is BDAc, not stock Not interested in your side notes nor your misinformation Noted. Just want to provde some ways to prevent me from asking stupid questions and doing stupid things... Peace Edited August 10, 2018 by Xd the great Link to comment Share on other sites More sharing options...
tys0n777 Posted August 10, 2018 Share Posted August 10, 2018 I know this is a stupid question and whatnot, but can I get the module manager for BDArmory? Every time I set my crafts to fight each other the missiles will destroy them but the guns have absolutely no effect on either crafts. Also when i fire up the weapons manager, I get the "Module manager is missing and it will cause the mod to not work properly". Link to comment Share on other sites More sharing options...
DoctorDavinci Posted August 10, 2018 Author Share Posted August 10, 2018 25 minutes ago, tys0n777 said: I know this is a stupid question and whatnot, but can I get the module manager for BDArmory? Every time I set my crafts to fight each other the missiles will destroy them but the guns have absolutely no effect on either crafts. Also when i fire up the weapons manager, I get the "Module manager is missing and it will cause the mod to not work properly". Here you go Link to comment Share on other sites More sharing options...
DJHonore Posted August 10, 2018 Share Posted August 10, 2018 I love this mod, but I'm getting some text in-game that says something to the effect of "Module Manager not found. BDArmoury will not work properly." Where can I find the module manager in question? Link to comment Share on other sites More sharing options...
DoctorDavinci Posted August 10, 2018 Author Share Posted August 10, 2018 23 minutes ago, DJHonore said: I love this mod, but I'm getting some text in-game that says something to the effect of "Module Manager not found. BDArmoury will not work properly." Where can I find the module manager in question? Look at the post directly above yours, it's right there, can't miss it Link to comment Share on other sites More sharing options...
tys0n777 Posted August 10, 2018 Share Posted August 10, 2018 5 hours ago, DoctorDavinci said: Here you go Thank you sir Link to comment Share on other sites More sharing options...
TheKurgan Posted August 10, 2018 Share Posted August 10, 2018 1 hour ago, DoctorDavinci said: Look at the post directly above yours, it's right there, can't miss it Gold. Link to comment Share on other sites More sharing options...
Box of Stardust Posted August 11, 2018 Share Posted August 11, 2018 I've just run a number of AI dogfights- - and there's a weird behavior where one team may not turn in to engage the other, or won't turn in to engage on time. It's very consistent on which planes it do it... or I think rather which planes cause it to happen to the other. Maybe. What might be causing this quirk? Altitude differences or something? Link to comment Share on other sites More sharing options...
1836440339 Posted August 11, 2018 Share Posted August 11, 2018 (edited) In my steam version of KSP1.4.5 , I find that in the hangar there's only eight BDAc parts can be shown And only when I delete all the other mods, (so in the gamedat folder there are only sqaud and BDAc and physic range extender), this problem can be sloved, and i can see all of the BDAc parts in hangar. I've tried different versions of KSP , and different versions of BDAc from githu, but it doesn't work. Is there any special data file i need to provide? the game didn't crash so i don't know if there is any other kind of data file except crash log Edited August 11, 2018 by 1836440339 Link to comment Share on other sites More sharing options...
Natso Posted August 11, 2018 Share Posted August 11, 2018 I know what my problem , that when i install Scatter my target port not working , i can't lock target and send gps , can i fix it?? Here my log : https://secufiles.com/mtT1/KSP.log Link to comment Share on other sites More sharing options...
Deddly Posted August 11, 2018 Share Posted August 11, 2018 @1836440339 just to let you know that the picture you posted is not visible here. We get only an error message in Chinese. Please can you try a different place to host your picture? Link to comment Share on other sites More sharing options...
Hojoz Posted August 11, 2018 Share Posted August 11, 2018 I wanna give everyone a tip regarding the missile decoupling and subsequent explosions. Angling the missile rail at 15 degrees away from the main fuselage on a wing fixes this for me. Yes, that means that the decouple speed at 10 and droptime at 1 solution isn't flawless. Link to comment Share on other sites More sharing options...
SpannerMonkey(smce) Posted August 11, 2018 Share Posted August 11, 2018 (edited) 5 hours ago, 1836440339 said: (so in the gamedat folder there are only sqaud and BDAc and physic range extender), Hi you are missing Module Manager , it is not optional and must be installed for the full functioning of BDA, A link to module manager is posted a few posts above your post. If you install module manager and the problems persist could you try the English version instead? I've been made aware of some problems with the translated version. And should the problems still remain after installing Module Manager and usingthe English version a zipped copy of your KSP.log will be needed as a first step in tracking down your problem . For reference the only correct file path for BDA should be. KSP/GameData/BDArmory , no other file path will allow the mod to work correctly ( File paths that do NOT work include , KSP/GameData/GameData/BDArmory and any variation of KSP/GameData/BDArmory.1.2..x.x.xxx) 4 hours ago, Natso said: I know what my problem , that when i install Scatter my target port not working , i can't lock target and send gps , can i fix it?? HI Scatterer and BDA target cam problems are a known issue, despite many attempts at resolving the problem. the issues remain. There is nothing as a user you can do to fix it , apart from uninstalling scatterer 7 minutes ago, Hojoz said: Yes, that means that the decouple speed at 10 and droptime at 1 solution isn't flawless. Hi did you fully shorten your missile rails as was mentioned in the same post? And ensure that the missile was sufficiently clear of obstructions. Edited August 11, 2018 by SpannerMonkey(smce) Link to comment Share on other sites More sharing options...
1836440339 Posted August 11, 2018 Share Posted August 11, 2018 @Deddly I've changed the image site to imgBB and uploaded again, can it be seem now? Link to comment Share on other sites More sharing options...
Deddly Posted August 11, 2018 Share Posted August 11, 2018 2 minutes ago, 1836440339 said: @Deddly I've changed the image site to imgBB and uploaded again, can it be seem now? Works perfectly now, thanks! Link to comment Share on other sites More sharing options...
Recommended Posts